Flare Nut Torque Chart. Torque Specs Wheel Lug Nuts Flare Identification Chart 195 Federal Hill Road Oxford, MA 01540 Phone: 508-987-2660 Fax: 508-987-2661 [email protected] Fedhillusa.com 10mm x 1.0 Asian nut with SAE/ This is considered the Wrench Resistance (WR) position
VAF Forums View Single Post Newbie Question on tube flaring from vansairforce.com
Tighten assembly with wrench until a solid feeling is encountered. Flaretite Seal Recommended Torque Specifications Torque recommendations for 37° and 45° Flare Fittings
VAF Forums View Single Post Newbie Question on tube flaring
This is considered the Wrench Resistance (WR) position Slide nut on tube, threaded end facing end of tube Over-tightening and dirt can damage fittings and/or tube causing leaks permit tightening to the exact torque required for best performance, economy and safety Flare tube following flaring tool manufacturers instructions (check flare quality) Thread nut on to fitting body "handtight" Flare Nut Torque Wrench Holding Wrench Torque Wrench All refrigerant pipes and connections MUST BE INSULATED SEPARATELY Gas Pipe Connection Cable Finishing Tape
SAE J513 dimensions short long flare nuts Knowledge Yuyao Jiayuan. Flaretite Seal Recommended Torque Specifications Torque recommendations for 37° and 45° Flare Fittings Listed, these FLARE SAE 45° fittings and NPT Pipe Fittings meet functional requirement of: - SAE J512, 45° + Flare - SAE J513C, ASA and ARI 720-55 (All flare SAE) - Military std and ASTM ANSI B70-1 (All flare SAE) - U.S
Torque Spec Chart For Lug Nuts. a) Measure flare diameter b) Examine flare for excessive thin out Flaretite Brochure Our current brochure, available for download